木塑室内地板安装步骤

Installation steps of wood plastic indoor floor

1、由于木塑地板本身的密度较大，在使用自攻螺钉的位置均需用钻头引孔，再进行自攻螺钉的紧固，预钻孔的直径应比螺钉直径小1/4。

1, because the wood plastic floor itself density is big, in the use of self tapping screw position need to drill hole, and then self tapping screw fastening, pre drilling diameter should be smaller than the diameter of screw 1/4.

2、在木塑地板上钉直钉需要更大的力，用尽全力的锤打直钉可能使直钉飞出，正确的做法是：轻轻的将直钉敲进1.5厘米以上，然后再用全力或用钉*将其打入。

In 2, wood flooring nail nail straight requires more force, trying to hammer straight nails may make straight nails fly out, the correct approach is: gently straight nails into more than 1.5 cm, and then to put on the nail or *.

3、当型材宽度大于8cm时，每个端头应以两根螺钉固定。

3, when the width of the profile is greater than 8cm, each end should be fixed with two screws.

4、固定封边木塑地板的自攻螺钉间距在400mm~600mm。也可以选用其他金属封边条作为木塑地板的封边。

4. The spacing of self tapping screws for the fixed edge wood plastic flooring is 400mm~600mm. Other metal edge banding can also be used as the edge of wood plastic flooring.